LIFT GATE. GATE & HARDWARE.. 2013 Volkswagen Golf

Lift gate. Rear.

A device that is installed in the hood that when removed allows any water to be removed from being inside the hood panel. A removable plug which allows the Decklid to be drained. hose. Deck. Hardware kit. Hood. Lift gate. Trunk.

Bumper. Left. Right.

Hinge. Left. Rear. Right.

Hinge nut. Left. Right. A Nut used to retain the Floor Pan Reinforcement to it's mounting point. A Nut used to secure the drive motor battery pack charger to its mounting point. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Convertible Top Hinge. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Decklid Hinge. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Floor Extension. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Floor Pan Crossmember. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Instrument Panel Crossmember. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Transmission Support. Automatic Transmission Mount Nut. Catalytic Converter Nut. Console Nut. Engine Air Intake Resonator Nut. Engine Cradle Nut. Hood Hinge Nut. Liftgate Hinge Nut. Part cannot be reused/reinstalled. Part is not reusable. replace only. Seat Back Frame Nut. Steering Column Nut. Included with: Resonator.

Hinge bolt. Left. Right.

Left. Right.

Left. Rear. Right. Strut upper retainer. A Stud attachment point for the deck lid Support Strut. Hood Lift Support Stud. Liftgate Support Strut Holder. Included with: Strut, Strut cylinder, Support cylinder, Support Strut.

Left. Right. Hood Lift Support Clip. Hood Lift Support Stud. Liftgate Support Strut Holder. Gate Strut Holder. Hood Stud. Mount. Strut clamp. Included with: Strut, Support Cylinder.

Ball stud. Left. Rear. Right.

Left. Lower mount.

Lower mount. Right.

Left. Lower mount bolt. Right. A Screw that is used to secure the Hybrid Voltage Converter to it's Mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Console Trim Panel to it's Mounting point. Attaches the Roll Bar to the floor, chassis or body structure. Bolt hat secures the Air Bag Impact Sensor. Bolt to secure the Roof Header Panel. Bolt used to Mount the radiator shutter assembly to the vehicle. Bumper Cover Reinforcement Bolt. Bumper Cover Reinforcement Screw. Bumper Impact Absorber Bolt. Bumper Impact Bar Bolt. Console Compartment Bolt. Door Interior Trim Panel Screw. Headlight Mounting Bolt. Liftgate Lift Support Bolt. Quarter Panel Trim Panel Screw. Radiator Support Panel Bolt. Seat Armrest Bolt. Tie Down Hook Bolt. Tie Down Hook Screw. Trunk Trim Panel Screw.

Rear Outer. Release handle. Deck Lid Lock. Deck Lid Release Solenoid. Handle to open liftgate. AND Amplifier; cylinder. controller. Actuator Assembly. Adjust motor. Deck Lid Release Solenoid. Gate cap. Guide pin. Handle, outside. Liftgate Latch Handle. Mechanism. Microswitch. Opener Assembly.

Release handle gasket. A component which provides a sealing surface at the Decklid Lock Cylinder. Liftgate Latch Handle Gasket. solenoid. Deck Lid Lock. Liftgate Latch. Included with: Opener assembly, Release Handle, Release solenoid.

Microswitch screw. A Bolt for a beam axle. A Bolt used to attach the blind spot detection warning Sensor to its mounting point. A Screw that is used to secure the Active Suspension System Height Sensor to it's mounting point. A Screw which holds the instrument panel cover to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Active Suspension System Height Sensor to it's mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Liftgate Lock Actuator to it's mounting point. Headlight Level Sensor Bolt. Part cannot be reused/reinstalled.

Emblem. Rear. Emblem or Ornament used on the Deck Lid. Hatch Emblem. Deck Lid. HANDLE. Hatch. Latch ASSEMBLY. Nameplate. Panel. VW SIGN. Included with: Opener assembly, Release handle, Release solenoid.

Lock. Rear.

Lock bolt. A bolt which retains the deck lid lock cylinder to its mounting point. Deck Lid Latch Bolt. Liftgate Latch Bolt. Liftgate Latch Screw. AND switch. Liftgate Screw.

Rear. Striker. Deck Lid Striker. Liftgate Lock Striker Plate. and Amplifier; catch. Carrier. Deck Lid. Latch. Liftgate. REINFORCED.

Striker bolt.

Rear. Weatherstrip.

Harness shield. A rubber ring with a hole in the center which provides protection through which Liftgate related components pass through. Tailgate Wiring Harness.